On this page
Common HVAC repairs in Kelso
- Heat pump not cooling on humid summer days — low refrigerant, frozen coil, or failing capacitor.
- Furnace short-cycling in winter — dirty flame sensor, oversized equipment, or thermostat miscalibration.
- AC blowing warm air — condenser-fan failure, tripped high-pressure switch, or refrigerant leak.
- Uneven temperatures room-to-room — failing zone damper, duct leakage, or blower-motor issue.
- Loud banging, squealing, or grinding from the air handler — bearings, belt, or blower-wheel imbalance.
- Thermostat shows the right setpoint but the system won't start — control board, transformer, or wiring fault.
- Water pooling at the air handler — clogged condensate drain or cracked pan.
- Frozen evaporator coil that keeps icing over — airflow restriction or low charge.
Ranked shortlist
Request quotes →- Twin City SrvcTop pick
What customers say “Had the guys from Twin City come out last winter when our old Traine all in one heat pump went out. Gave me my options…”
- Carlson S Heating A CVerified
What customers say “Carlsons heating across the board made a stressful time for us a lot better. Our electric forced air furnace finally…”
- Custom Heating CoolingVerified
What customers say “Best HVAC company in the Pacific NW! Josh was very professional and knowledgeable and great pricing. We built a new…”
- Consistent Clmt Htg ClgVerified
- Nw Solutions Heating AirVerified
Repair vs replace: quick decision tree
- Age > 15 years — Expect diminishing returns on any single repair. Start pricing replacement in parallel, especially if a second failure in the last 24 months.
- Repair cost > 50% of replacement — A $2,500 repair on an $8,000 system rarely pencils. Run the 5-year math: repair cost + likely follow-on failures vs new-system financing.
- Uses obsolete refrigerant (R-22) — R-22 is phased out; refills are both expensive and short-lived. Replacement is almost always the right call.
- Failed a major component (compressor, heat exchanger) — These are “the system”. A compressor on a 12-year-old condenser is a replacement signal, not a repair.
Typical repair cost range
Diagnostic fees typically run $85–$150 and are often credited toward the repair. Simple swaps (capacitor, ignitor, thermostat) land at the low end; major component replacements (blower motor, control board) push toward the high end.
Estimate your Kelso repair
Pick the repair type and your system's age for a ballpark range. Real quotes vary by part availability and diagnosis — use this as a sanity check before approving work.
Frequently Asked Questions
How long does a typical HVAC repair take in Kelso?
Most diagnoses take 30–60 minutes on site. Small repairs (capacitor swap, thermostat, ignitor) finish the same visit. Parts-on-order repairs can push the job 1–5 business days depending on supplier stock.
Do repairs come with a warranty?
Labor warranties of 30–90 days are common; parts usually carry the manufacturer's warranty (1–10 years). Always get the warranty terms in writing on the invoice before the tech leaves.
How do I avoid common repair scams?
Red flags: no written estimate before work starts, refrigerant refill with no leak search, blanket recommendation to replace without an inspection, or very high "after-hours" pricing on a non-emergency call. Two written quotes for any repair over $600 is the fastest sanity check.
When should I replace instead of repair?
When the repair estimate exceeds 50% of a new system, or the unit is past 15 years, or it uses obsolete refrigerant (R-22), replacement usually wins the 5-year math. Otherwise repair is almost always the better call.
Licensing verified weekly. Reviews refreshed within the last 30 days.
Licensing data: Washington Department of Labor & Industries (L&I) · Company data: verified business records + Google Business profile
See our editorial standardsReport inaccurate info about HVAC repair in Kelso
Get Kelso repair quotes
Two or three written quotes is the fastest way to normalize a repair bill — we'll connect you with top-ranked local pros.